Hasil Pencarian  ::  Simpan CSV :: Kembali

Hasil Pencarian

Ditemukan 31 dokumen yang sesuai dengan query
cover
Buyung Zainal Abidin
Depok: Fakultas Teknik Universitas Indonesia, 1991
S36334
UI - Skripsi Membership  Universitas Indonesia Library
cover
Muhammad Novel Hidayat
"ABSTRAK
Untuk mendapatkan temperatur pendinginan yang rendah diperlukan perbedaan tekanan yang tinggi. Perbedaan tekanan yang sangat tinggi mengakibatkan kerja kompresor semakin berat. Hal ini mengakibatkan turunnya efisiensi dari sistem refrijerasi sehingga perlu menggunakan sistem refrijerasi cascade. Pada pengeringan beku vakum diperlukan temperatur pendingin yang rendah pada evaporator yang berfungsi sebagai cold trap. Pengeringan beku vakum memerlukan energi untuk proses pengeringan dengan sublimasi sebesar 2870kJ/kg.s, dengan memanfaatkan panas buang kondenser sebagai pemanas dapat mengurangi waktu pengeringan. Oleh karena itu, perlu dilakukan analisa perubahan temperatur dan massa aliran refrijeran pada metode ini agar dapat mengetahui efisiensi sistem dan mengurangi energi yang dikonsumsi selama proses pengeringan berlangsung.

ABSTRACT
For reach of low refrigeration temperature is needed high difference pressure. High difference pressure cause increase compressor work. It is reduce efficiency of refrigeration system so need to use cascade refrigeration system. In freeze vacuum drying, is needed low refrigeration temperatur on evaporator which in function as cold trap. Freeze vacuum drying need energy for drying process by sublimation is 2870kJ/kg.s, by using heat loss condenser as heater can reduce drying time. Because of that, it is need to analyze of temperature change and flow rate refrijerant in this method to find out system efficiency and decrease energy consumption when drying process."
Fakultas Teknik Universitas Indonesia, 2011
S1124
UI - Skripsi Open  Universitas Indonesia Library
cover
Surya Fikri Utomo
"Kegiatan pengobatan dan penelitian biomedis membutuhkan cold storage untuk menyimpan spesimen biomedis seperti sel induk (stem cells), sperma, darah dan organ-organ lainnya dalam jangka waktu yang cukup lama. Organ-organ tersebut membutuhkan ruang pendingin yang mampu mencapai temperatur -130°C atau lebih rendah yang disebut ultra low cold storage (Aprea, 2009).
Sejatinya, refrigeran jenis CFC (Chloro-Fluoro-Carbon) memegang peranan penting dalam perkembangan sistem refrigerasi. Refrigeran CFC memiliki banyak keutamaan-keutamaan yang pada waktu itu sangat menguntungkan untuk dipergunakan sebagai komoditas refrigerant dunia. Penelitian pendahuluan simulasi dan eksperimental mesin pendingin cascade dua tingkat dengan refrigeran ramah lingkungan telah terbukti mampu mencapai -80oC (Nasruddin, 2008 & 2009), sehingga bila dilakukan penelitian lebih lanjut akan mencapai temperatur lebih rendah dari -100°C dengan mesin pendingin autocascade.
Pada percobaan ini hasil yang didapat adalah temperatur optimum yang mampu dicapai adalah -42°C, dengan pressure diatas 2 bar dengan komposisi propane 1100 gr dan ethane 200 gr. Meski high-system sudah dapat dikatakan baik, dengan mencapai -31°C, namun low-system masih perlu penelitian lebih lanjut mengenai komposisi refrijeran yang baik.

Medicine and biomedical research activities require cold storage to store the biomedical specimens such as stem cells, sperm, blood and other organs within a period of time. These organs require cooling chamber which is able to reach temperatures 130°C or lower, called ultra low cold storage (Aprea, 2009).
Indeed, refrigerant type CFC (Chloro-Fluoro-Carbon) plays an important role in the development of the refrigeration system. CFC refrigerants has many virtues which at that time was very advantageous to be used as the world refrigerant commodity. Preliminary simulation studies and experimental cascade refrigeration machine with two levels of environmentally friendly refrigerants have proven capable of achieving, -80°C (Nasruddin, 2008 & 2009), so if further investigation to reach temperatures lower than 100 oC with the engine-cooling autocascade.
In this experiment the results obtained are able to achieve the optimum temperature is -42°C, a pressure above 2 bar with a composition of 1100 gr propane and 200 gr ethane. Although high-system are well enough, reaching -31°C, but the low-system still needs further research on the best refrigerant composition.
"
Depok: Fakultas Teknik Universitas Indonesia, 2012
S42135
UI - Skripsi Membership  Universitas Indonesia Library
cover
Abdul Rafii Lazuardian Ramadhan
"Kebutuhan akan refrigeran sekunder yang dapat menyerap kalor dengan nilai tinggi sangatlah penting saat ini. Ice slurry sebagai media refrigeran sekunder memiliki kelebihan yang lebih unggul dibandingkan refrigeran sekunder lainnya seperti flat ice, block ice, maupun air tawar. Ice slurry dapat menyerap kalor lebih banyak jika dibandingkan dengan air tawar maupun air laut biasa, ini dikarenakan ice slurry menyimpan lebih banyak kalor laten. Jika dibandingkan dengan flat ice, maupun block ice, ice slurry memiliki keunggulan yaitu ice slurry dapat dialirkan menggunakan sistem perpipaan. Ini dikarenakan ice slurry merupakan larutan yang memiliki partikel es mikroskopis di dalamnya dengan fraksi es tertentu.

The secondary refrigerant which could absorb high amount of heat is very important and highly required. Ice slurry is an advanced secondary refrigerant media which is superior from other secondary refrigerant such as flat ice, block ice, or pure water. Ice Slurry can adsorb more heat if compared towards pure water or sea water. It is possible because Ice Slurry holds more latent heat. When compared towards flat ice or block ice, ice slurry is better in the flexible side because it able to be flowed by pipes. Its flexibility is caused of its form as a liquid which has microscopic ice particle inside with sorted ice fraction.
"
Depok: Fakultas Teknik Universitas Indonesia, 2017
S68078
UI - Skripsi Membership  Universitas Indonesia Library
cover
Gavin Cakraditya
"Tulisan dan penelitian ini dilakukan untuk melakukan perbandingan performa dari chiller dengan refrigerant R290 saat sebelum dan sesudah menggunakan sub-cooler/heat exchanger. Sehingga dapat memberikan perkiraan seberapa besar dampak penggunaan sub-cooler pada performa chiller. Penelitian ini dilakukan dalam rangka membantu pengembangan pemakaian chiller hidrokarbon di Indonesia, dimana minatnya sudah cukup tinggi dengan sifatnya refrigerant yang ramah lingkungan serta memiliki performa pendinginan yang lebih tinggi dari chiller dengan refrigerant R22 yang saat ini banyak digunakan. Melalui riset ini ditemukan bahwa penggunaan Sub-Cooler memberikan dampak kenaikan performa sebesar 6.9% pada beban pendinginan sedang, namun tidak memberikan perubahan signifikan pada performa saat beban pendinginan rendah.

The purpose of this research is to compare the performance of R290 hidrocarbon Chiller with sub-cooler and without sub-cooler, so that could give an estimation on how significant the impact made by sub-cooler in increasing chiller performance. This research also intended to helps the development of hydrocarbon chiller in Indonesia, which it's environmentally friendly and have higher performance than chiller with R22 as it's refrigerant. By doing this research, it was found that the use of sub-cooler when using it on medium cooling load operation could increase performance by 6.9%, but did not have significant effect in performance when using it on low cooling load operation."
Depok: Fakultas Teknik Universitas Indonesia, 2020
S-pdf
UI - Skripsi Membership  Universitas Indonesia Library
cover
Dani Arsanto
Depok: Fakultas Teknik Universitas Indonesia, 2001
S37091
UI - Skripsi Membership  Universitas Indonesia Library
cover
cover
Richardo Ariyanto
"Salah satu cara untuk meningkatkan efisiensi perangkat AC adalah dengan mengubah sistem menjadi Air Conditioner Water Heater (ACWH). Kalor yang dikeluarkan oleh sistem sebagai hasil dari kondensasi refrigeran akan ditangkap dan selanjutnya digunakan untuk memanaskan air, meningkatkan efisiensi dari perangkat AC. Penelitian ini menghasilkan suatu konsep sistem kendali yang dapat mengatur mode aliran refrigeran pada sistem ACWH, baik menuju air cooled condenser maupun menuju condenser water heater. Temperatur serta tekanan refrigeran pada sisi discharge kompresor serta temperatur pada tangki pemanas air dideteksi oleh perangkat akuisisi data, yang selanjutnya diolah dengan menggunakan aplikasi LabVIEW pada komputer. Aplikasi mengirimkan perintah kepada relay katup solenoid refrigeran yang mengatur aliran refrigeran ke condenser water heater. Perintah kepada relay ditransmisikan dengan metode komunikasi serial melalui perangkat mikrokontroler Arduino. Hasil pengujian untuk setpoint temperatur air panas 45°C, sistem berhasil mempertahankan temperatur air antara 45.6 °C dan 44.6°C. Rancang bangun sistem kendali yang dihasilkan memudahkan pengguna dalam mengoperasikan serta menampilkan status alat ACWH, dan memastikan komponen alat ACWH berjalan dalam batas aman selama dalam proses pemanasan air.

One of the methods that can be used to increase the efficiency of an Air Conditioning system is to convert it into an Air Conditioner Water Heater (ACWH) system. The heat released by the system due to refrigerant condensation will be captured and further used to heat the water, increasing the efficiency of the air conditioning device. This research resulted in a control system concept that can regulate the refrigerant flow mode in the ACWH system, both to the air-cooled condenser and to the condenser water heater. The data acquisition device detects the refrigerant's temperature and pressure on the compressor's discharge side and the temperature in the water heater tank, which is then processed using the LabView application on the computer. The application sends commands to the refrigerant solenoid valve relay that regulates the refrigerant flow to the condenser water heater. Commands to the relay are transmitted by serial communication method through Arduino microcontroller devices. Test results for a hot water temperature setpoint of 45°C, the system successfully maintained a water temperature between 45.6°C and 44.6°C. The resulting control system design makes it easier for users to operate and display the status of the ACWH system. It ensures that the components of the system run within safe limits during the water heating process."
Depok: Fakultas Teknik Universitas Indonesia, 2023
S-pdf
UI - Skripsi Membership  Universitas Indonesia Library
cover
Kwang-Il Choi
"Experimental investigation on two-phase flow boiling heat transfer of R-410A and R-134A in horizontal small tubes is reported. The pressure drop and local heat transfer coefficients were obtained over heat flux range of 5 to 40 kW/m2 , mass flux range of 70 to 600kg/ m2 s, saturation temperature range of 2 to 12°C, and quality up to 1.0 in test section with inner tube diameters of 3.0 and 0.5mm, and lengths of 2000 and 330mm, respectively. The section was heated uniformly by applying a direct electric current to the tubes. The effects of mass flux, heat flux, and inner tube diameter on pressure drop and heat transfer coefficients are presented. The experimental results are compared against several existing correlations. A new boiling heat transfer coefficient correlation based on the superposition model for refrigerants in small tubes is also presented."
Depok: Faculty of Engineering, Universitas Indonesia, 2011
UI-IJTECH 2:2 (2011)
Artikel Jurnal  Universitas Indonesia Library
cover
Kafi`uddin
"Dalam penelitian ini membahas tentang studi refrigeran campuran R-290/134a (70/30 % berat) sebagai pengganti R-22, di mana di dalamnya rnenerangkan atas alasan pemilihan campuran refrigeran dan koinposisinya dengan analisa sifat-sifat termodinamikanya yang dibantu program REFPROP 6.01. Penelitian dilanjutkan dengan membandingkan unjuk kerja refrigeran yang telah ditetapkan campurannya dengan R-22 dan R-290 dalam sistem pendingin.
Parameter pengujian yang dilakukan adalah dengan menyamakan efek pendinginan yang diperoleh melalui pengaturan banyak pengisian refrigeran dengan kondisi sisi sekunder yang sama. Kemudian pengujian dilakukan dengan melakukan perubahan temperatur udara inlet evaporator pada sisi sekunder dengan kondisi pendinginan di kondensor tetap.
Hasil yang diperoleh menunjukkan bahwa.Refrigeran campuran R-290/134a (70/30) menunjukkan unjuk kerja yang lebih baik dibandingkan dengan R-22, dan sedikit lebih buruk dibandingkan dengan R-290. Sebagai refrigerant baru, refrigeran campuran ini dapat dijadikan sebagai salah satu pilihan diantara banyak refrigeran pengganti yang ditawarkan saat ini, karena refrigeran campuran ini dapat langsung dipakai pada sistem R-22 yang sudah ada dan memiliki harga indeks GWP yang jauh lebih rendah dari R-22.

The present Thesis describes the differences between the refrigerant R-22 and the replacement candidates R-290 and the zeotropic refrigerant R-290/R-134a (70/30 % weight). The study of the composition of blends was performed to determine the mass fraction of each component in the mixtures that are most promising on the basis of work pressure.
Starting from the thermodynamic point of view, different methods of comparison will be applied :
a) The theoretical comparison using thermo dynamical calculation leading to results as if the different fluids worked each in physically optimized system for the fluid in the ideal cycle of the refrigeration system.
b) The experimental comparison in concerning the external behavior based on equal secondary fluid temperatures taking in the evaporator and condenser also into account the heat exchange in the evaporator, and The result show that the zeotropic refrigerant mixtures were used as working fluids shown to increase the coefficient of performance (COP) by 7% compared R-22, but the propane (R-290) performs up to 16% better than the refrigerant mixtures. The conclusion of this study is the refrigerant mixtures R-290/134a (70/30 % weight) can be used at all air conditioning system, because approximately they work at the same pressure.
"
Depok: Fakultas Teknik Universitas Indonesia, 2002
T3685
UI - Tesis Membership  Universitas Indonesia Library
<<   1 2 3 4   >>