Hasil Pencarian  ::  Simpan CSV :: Kembali

"It contains an extensive theoretical description of the method as well as numerous examples of application to a wide range of materials (composites, metals, welds, biomaterials etc.) and situations(static, vibration, high strain rate etc.). Finally, it contains a detailed training section with examples of progressive difficulty to lead the reader to program the VFM. This is accompanied with a set of commented Matlab programs as well as with a GUI Matlab based software for more general situations."

"This book has been rigorously re-written and updated for its second edition to offer the latest findings in the mechanical behaviour of materials. Includes chapter-end exercises, and many explanatory diagrams and electron-microscope photographs. "

"Mechanical alloying (MA) was used to produce Ti-xMg alloys (x = 0, 2.5, 5, 7.5, 10 wt%Mg), and powders alloys of Ti-Mg were characterized by X-ray diffraction and Optical microscope. Investigation shows that the homogenous structure have not yet been obtained as milling Ti and Mg for 4 hours, but XRD traces indicated that mechanical alloying have produced Ti-Mg alloys as Mg peaks has disappeared from the traces. XRD results also showed that mechanical alloying and addition of Mg have direct effect on XRD broadening. Powder alloys were compacted using severe plastic deformation method, ECAP. Using Archimedes principle the density of Ti-Mg solid samples were measured and results shows that the density decreased as Mg content increases. Relative density on compacted powders indicates that ECAP has produced in excess of 98% density on each sample, and annealing improved the density. Microstructure observation using SEM shows that ECAP has produced good inter-particles boundaries as well as some porosity and undissolved Mg particles can be observed. After annealing there is improvement in boundaries in samples containing Mg, but at the same time cause segregation of Mg, which indicates diffusion of Mg occurs faster during annealing at 600_C. Mechanical properties measurement was conducted by ball indentation test method on annealed and un-annealed bulk samples, and the result were studied and analysed carefully, however, the final result of mechanical properties were not well understood and still require further and deeper investigation in the future."