Hasil Pencarian  ::  Simpan CSV :: Kembali

Hasil Pencarian

Ditemukan 8305 dokumen yang sesuai dengan query
cover
Xanthakos, Petros P.
New York: McGraw-Hill, 1979
624.183 4 XAN s
Buku Teks SO  Universitas Indonesia Library
cover
Syahdhan Chairman
"Ice slurry memberikan kualitas sistem penyimpanan ikan yang lebih baik. Rheology pada ice slurry masih perlu diteliti lebih jauh, Salah satu bagian dari rheology ice slurry adalah transport characteristic. Ttansport characteristic pada aliran ice slurry merupakan satuan energi pendinginan yang didapat dari ice slurry yang dialirkan pada kecepatan tertentu. Ice slurry dalam penelitian ini menggunakan campuran air tawar dan 20% Natrium Klorida sebagai freezing depressant. Ice slurry yang dibuat dengan ice slurry generator di laboratorium pendingin Departemen Teknik Mesin Fakultas Teknik Universitas Indonesia mencapai suhu terendah -15℃ selama 12 jam proses pembuatan. Ice slurry yang didapat mencapai ice mass fraction sebesar 83% ini dialirkan pada pipa ½ inci dengan panjang pipa 2 meter. Variasi kecepatan yang digunakan untuk mengalirkan ice slurry dari 0,34 hingga 1,00 meter per detik. Transport characteristic terbesar yang dicapai dalam penelitian ini adalah 357,92 kW ketika 80% fraksi es dealirkan dengan kecepatan 1,00 meter per detik., Fraksi es yang lebih tinggi dan debit yang lebih rendah baik digunakan dalam sistem penyimpanan ikan. Hal ini dikarenakan ratio antara transport characteristic dan power pompa lebih tinggi pada kecepatan rendah.

Ice slurry provides a better quality of fish storage system. Rheology on ice slurry still needs to be investigated further. One part of ice slurry rheology is transport characteristic. Tansport characteristic in the ice slurry flow is a cooling energy unit obtained from ice slurry which is flowed at a certain speed. Ice slurry in this study used a mixture of fresh water and 20% sodium chloride as a freezing depressant. Ice slurry generated by ice slurry generators in the refrigeratrion laboratory, Department of Mechanical Engineering, Faculty of Engineering, University of Indonesia reaches the lowest temperature of 14 during the 12 hour generation process The ice slurry obtained reached 83% of ice mass fraction flowed in the ½ inch pipe with a pipe length of 2 meters. Flowrate variations are used to flow ice slurry from 0.34 to 1.00 meters per second. The highest transport characteristic achieved in this study was 357,92 kW when 80% of the ice fraction was distributed at a speed of 1,00 meters per second. Higher ice fractions and lower discharge is great for fish storage systems. Because of the ratio between transport characteristic and pump power is higher at low speeds"
Depok: Fakultas Teknik Universitas Indonesia, 2019
S-pdf
UI - Skripsi Membership  Universitas Indonesia Library
cover
Abulnaga, Baha E.
New York: McGraw-Hill, 2002
621.867 2 ABU s
Buku Teks SO  Universitas Indonesia Library
cover
New york : ASCE, 1994
627.4 RET
Buku Teks  Universitas Indonesia Library
cover
"Trimethylolethane (TME) trihydrate slurry is a proper phase-change material for latent heat transportation in cooling systems since it has excellence heat transfer performance and high thermal capacity...."
Artikel Jurnal  Universitas Indonesia Library
cover
Pálossy, László, 1928-
Budapest : Akadémiai Kiadó, 1993
624.164 PAL e
Buku Teks SO  Universitas Indonesia Library
cover
Sitompul, Gibson Harsoning
"Bangunan hotel merupakan suatu bangunan dengan peruntukan komersil yang dapat terbilang memiliki kompleksitas terhadap desain perancangan dalam memenuhi aspek yang dibutuhkan. Oleh karena itu, dapat dilakukan penelitian secara ilmiah untuk memberikan hasil yang lebih optimal dari segi perancangan dan biaya yang dikeluarkan, tanpa mengabaikan kekuatan dari struktur bangunan. Sistem struktur yang dibandingkan dalam penelitian ini adalah post-tensioned flat slab dan sistem ganda dinding geser beton dengan rangka pemikul momen khusus. Tujuan dari penulisan ini adalah untuk mengetahui perbandingan kelayakan struktur antara kedua sistem bangunan akibat gaya gempa yang diberikan, serta efektivitas biaya pekerjaan. Analisis pada penelitian ini menggunakan gempa respon spektrum depok dan riwayat waktu linear, dengan software analisis yang digunakan adalah ETABS. Dari denah arsitektur hotel yang diberikan, penulis mendesain ulang struktur pada kedua sistem hingga mendapatkan hasil yang paling optimal untuk dibandingkan. Dengan segala keunggulanya, sistem post-tensioned flat slab memberikan hasil yang lebih baik dari segi efesiensi volume material dan biaya, walaupun diperlukan beberapa optimasi desain struktural untuk mendekati performa ketahanan lateral akibat gaya gempa seperti sistem ganda konvensional.

The hotel building is a commercial structure that possesses complexity in its design to meet the required aspects. Therefore, scientific research can be conducted to provide more optimal results in terms of design and cost without neglecting the strength of the building structure. The structural systems compared in this study are the post-tensioned flat slab system and the dual system of concrete shear walls with special moment-resisting frames. The purpose of this writing is to determine the structural feasibility comparison between the two building systems due to the given earthquake forces, as well as the cost-effectiveness of the work. The analysis in this study uses the Depok response spectrum earthquake and linear time history, with the analysis software used being ETABS. From the given architectural plan of the hotel, the author redesigned the structure in both systems to obtain the most optimal results for comparison. With all its advantages, the post-tensioned flat slab system provides better results in terms of material volume efficiency and cost, although some structural design optimizations are needed to approach the lateral resistance performance due to earthquake forces like the conventional dual system."
Depok: Fakultas Teknik Universitas Indonesia, 2024
S-pdf
UI - Skripsi Membership  Universitas Indonesia Library
cover
cover
Bell, Brian J.
London: MacDonald & Evans, 1974
624.153 3 BEL r
Buku Teks  Universitas Indonesia Library
cover
Rino Bagas Nugroho
"ABSTRAK
Indonesia merupakan negara kepulauan dengan tingkat resiko terhadap gempa bumi yang cukup tinggi. Namun beberapa bangunan gedung di Indonesia dibangun sebelum diterapkannya standar perencanaan ketahanan gempa, SNI 03-1726-1989 yang kemudian diperbaharui menjadi SNI 03-1726-2002, sehingga diperkirakan tidak memperhitungkan aspek-aspek ketahanan gempa pada saat bangunan tersebut dibangun. Gedung X adalah bangunan beton bertulang portal terbuka empat (4) lantai yang dibangun pada tahun 1965 dan merupakan salah satu bangunan yang dimaksud.
Penelitian ini dilakukan untuk mengevaluasi kinerja struktur eksisting Gedung X untuk memastikan kelayakan struktur bangunan dalam mengakomodir beban gempa sesuai SNI 03-1726-2002. Apabila ditemukan ketidaksesuaian struktur dalam menahan beban gempa maka dibutuhkan suatu perencanaan metode perbaikan (perkuatan/retrofit) terhadap bangunan tersebut sehingga bangunan itu dapat memenuhi kualifikasi ketahanan gempa sesuai dengan SNI 03-1726-2002 hingga umur pakainya berakhir. Salah satu metode perbaikan yang paling umum digunakan adalah dengan menambahkan elemen baru pada struktur gedung eksisting berupa penambahan dinding geser dan bresing baja konsentrik biasa.
Berdasarkan hasil penelitian, penambahan elemen dinding geser dan bresing baja dapat memperbaiki defisiensi¬defisiensi yang ada pada Gedung X sehingga ketahanan bangunan eksisting terhadap gempa pun meningkat.

ABSTRACT
Indonesia is an archipelago with high level of seismic risk. However, some buildings in Indonesia was built before the adoption of seismic resistance standards of planning, SNI 03-1726-1989 which was then updated to SNI 03-1726-2002, so it could be assumed that the seismic resistance aspects were not taken into account when the building was built. X Building is an open frame reinforced concrete building and one of buildings in question.
This study was conducted to evaluate the performance of existing structures of X Building to ensure the feasibility of its structures to accommodate seismic loads in accordance with SNI 03-1726-2002. If discrepancies is found in the structures, it needs a repairing (strengthening/retrofit) method plan so that the building qualifies for seismic resistance in accordance with SNI 03-1726-2002 until its expiry date. One of the most common retrofit method is to add new elements to the existing building with addition of shear walls and ordinary concentric braced frame.
Based on the results of the study, the addition of shear walls and braced frame can remove the deficiencies that occur, so the resistance of X Building against seismic increased."
Depok: Fakultas Teknik Universitas Indonesia, 2011
S822
UI - Skripsi Open  Universitas Indonesia Library
<<   1 2 3 4 5 6 7 8 9 10   >>